K 1500 Truck 4WD V8-5.3L VIN T (2000)
Brake Pad: Specifications
Inspect the brake linings every 9,650 km (3,000 mi) or any time you remove the wheels. Tire rotation is an example of wheel removal.
1. Inspect both ends of the outer lining by looking in at each end of the caliper. The ends are the points where the highest rate of wear normally
occurs.
2. Check the thickness of the inner lining in order to ensure the lining has not worn prematurely. Look down through the inspection hole in the top of
the caliper in order to view the inner lining.
3. Replace the shoe and the lining assemblies whenever the thickness of any lining wears to within 0.1.5 mm (0.060 inch) of the shoe. Always
replace the disc brake shoe and the lining assemblies as complete sets.
4. Inspect the flatness of the linings. Place the inboard and the outboard lining surfaces together. Inspect for a gap between the surfaces. Any gap
should not exceed 0.30 mm (0.012 inch) at the center of the lining surfaces. This applies to both the new and the used shoe and lining assemblies.
The lining assemblies have a wear indicator that makes noise when the linings are worn and need replacement.
