K 1500 Truck 4WD V8-5.3L VIN T (2000)
1. Place the J 21370- 10 in the servo bore.
2. Position the J 38737 over the bore with the hex nut facing the parking pawl linkage.
Notice: Refer to Fastener Notice in Service Precautions.
3. Fasten the J 38737 with the two rear servo cover bolts.
Tighten the bolts to 24 Nm (18 ft. lbs.).
4. Ensure the J21370-10 moves freely in the tool and the pin bore.
5. In order to determine the correct pin length, tighten the nut on the gauge.
Tighten the nut to 34 Nm (25 ft. lbs.).
