K 1500 Truck 4WD V8-6.0L VIN U (2001)
Tighten the bolt to 40 N.m (30 lb ft).
Note:
When adding fluid to the brake master cylinder reservoir, use only Delco Supreme II(R), P/N 12377967 (Canadian P/N 992667), or equivalent
DOT-3 brake fluid from a clean, sealed brake fluid container. The use of any type of fluid other than the recommended type of brake fluid may
cause contamination which could result in damage to the internal rubber seals and/or rubber linings of hydraulic brake system components.
11.
Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding in Hydraulic Brakes.
12.
Remove the caliper bracket bolts.
13.
Reposition the caliper and bracket on top of the rear leaf spring.
14.
Remove the caliper guide pin bolts.
15.
Install the two new brake caliper guide pin bolts from the Shield Kit, P/N 15188166.
Tighten
Tighten the caliper guide pin bolts to 108 N.m (80 lb ft).
16.
Install one shield and two nuts from the shield kit.
Tighten
Tighten the shield retaining nuts to 45 N.m (33 lb ft).
17.
Install the caliper and bracket onto the rotor.
18.
Install the caliper bracket bolts.
Tighten
^
For RPO JH5, tighten the caliper bracket bolts to 200 N.m (148 lb ft).
