K 1500 Truck 4WD V8-6.0L VIN U (2001)
Oil Line: Service and Repair
Engine Oil Cooler Hose/Pipe Replacement
Removal Procedure
1. Perform the following steps on both the upper and lower radiator quick connect fittings:
1.1.
Disengage the plastic caps from the quick connect fittings. Pull the caps back along the pipes.
1.2.
Hold one leg of the retaining clip.
1.3.
Using a small pick-type tool (or bent screwdriver) gently pry the other end of the retaining clip from the quick connect fitting.
1.4.
Rotate the retaining clip out of the quick connect fitting. Remove the retaining clip completely.
1.5.
Discard the OLD retaining clips.
2. Remove the oil cooler pipes from the retainer clip.
3. Gently pull the oil cooler pipe fittings straight out from the radiator quick connect fittings.
4. Raise and suitably support the vehicle with safety stands. Refer to Vehicle Lifting.