K 1500 Truck 4WD V8-6.0L VIN U (2001)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position (CKP) Sensor Replacement
REMOVAL PROCEDURE
CAUTION:
^
Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF,
unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal,
also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or
its components.
^
Refer to Battery Disconnect Caution in Service Precautions.
IMPORTANT: Perform the CKP System Variation Learn Procedure when the crankshaft position sensor is removed or replaced.
1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Remove the starter.
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
