K 1500 Truck 4WD V8-6.0L VIN U (2001)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case assembly.
3. Remove the transfer case input shaft seal.
Installation Procedure
Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing away from the transfer case assembly. The
input shaft seal should be even with the surface of the transfer case after installation.
1. Position the transfer case input seal on the input shaft.
2. Using the J 42738, install the input shaft seal in the transfer case.
3. Install the transfer case assembly.
4. Check the transfer case fluid level.
5. Lower the vehicle. Refer to Vehicle Lifting.
