K 1500 Truck 4WD V8-6.0L VIN U (2001)
9. Insert a flat-tipped screw driver or small pry bar in the space between the outer race of the seal and the transfer case.
10. Pry the outer race out of the transfer case.
11. Remove the outer part of the seal.
Installation Procedure
1. Install the J 43484 (2) to the J 8092 (1).
2. Install the transfer case front output shaft seal on the J 43484 (2).
3. Using the J 43484 (2) and the J 8092 (1), install the transfer case output seal.
4. Install the front propeller shaft.
5. Check the transfer case fluid level.
6. Install the transfer case shield.
7. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
^
Tools Required
