K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
Power Seat Switch: Service and Repair
Lumbar Switch Replacement (Power)
Power Split Bench
REMOVAL PROCEDURE
1. Remove the screws attaching the switch to the side of the seat cushion.
2. Pull the switch partially out of the seat cushion.
3. Remove the switch from the switch bezel.
4. Remove the switch wiring harness in-line connector.
5. Remove the switch and the wiring harness from the side of the seat cushion.
INSTALLATION PROCEDURE
1. Route the switch wiring harness through the opening in the side of the seat cushion and through the opening in the seat frame.
2. Install the switch wiring harness to the vehicle wiring harness.
3. Install the switch wiring harness in-line connector.
4. Install the switch into the switch bezel.
5. Position the switch bezel into the seat cushion opening.
6. Install the screws.
Power Bench Seat
REMOVAL PROCEDURE
1. Remove the screws attached to the side of the seat cushion.
2. Pull the switch partially out from the seat cushion.
3. Remove the switch from the switch bezel.
4. Remove the switch wiring harness in-line connector.
5. Remove the switch and the wiring harness from the side of the seat cushion.
