K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
REMOVAL PROCEDURE
1. Remove the caliper. Do not disconnect the brake hose as in Caliper.
2. Suspend the caliper.
NOTICE: Do not allow calipers to hang from the flexible hoses. Doing so can damage the hoses.
3. Remove the inboard lining.
4. Remove the outboard lining.
5. Inspect the caliper assembly for signs of fluid leakage. If any leakage is detected refer to Brake Caliper Overhaul (Rear; Front Bendix).
6. Use a wire brush to remove any corrosion from the machined surfaces of the steering knuckle and the caliper.
INSTALLATION PROCEDURE
1. Lubricate the caliper and the steering knuckle, or support, sliding surfaces and the spring with Shell Aeroshell #5 or the equivalent.
2. Place the new pad in a vise.
3. Compress the vise as needed to obtain a secure fit between the outer brake pad and the caliper.
