K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
Coolant Temperature Sensor/Switch (For Computer): Service and Repair
REMOVAL PROCEDURE
CAUTION: Refer to Battery Disconnect Caution in General Information.
1. Remove the negative battery cables.
2. Drain the cooling system below the level of the sensor.
3. Remove the electrical connector by releasing the locking tab.
4. Remove the sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Cautions and Notices.
1. Install the sensor into the engine.
Tighten
Tighten the sensor to 25 N.m (18 lb ft).
2. Install the electrical connector.
3. Refill the coolant system.
