K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
10. Remove the inlet heater hose from the thermostat housing and position out of the way.
11. Remove the thermostat housing crossover from cylinder heads. Refer to Thermostat Housing Crossover Replacement in Cooling System.
12. Remover the power steering pump from the accessory bracket. Refer to Power Steering Pump Replacement in Steering and Suspension.
13. Remove the bolts from the accessory bracket.
14. Remove the accessory bracket from the engine block.
15. Clean the mating surfaces of the cylinder and crossover.
INSTALLATION PROCEDURE
1. Install the accessory bracket to the engine block.
NOTICE: Refer to Fastener Notice in Service Precautions.
2. Install the accessory bracket bolts to the cylinder head.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
3. Install the power steering pump to the accessory bracket. Refer to Power Steering Pump Replacement in Steering and Suspension.
4. Install the thermostat housing crossover to the cylinder heads. Refer to Thermostat Housing Crossover Replacement in Cooling System.
