K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
Parking Brake Warning Switch: Service and Repair
REMOVAL PROCEDURE
CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF,
unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also
disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
1. Remove the negative battery cable.
2. Remove the electrical connector.
3. Remove the retainer from the switch.
4. Remove the parking brake indicator switch from the vehicle.
INSTALLATION PROCEDURE
1. Connect the parking brake indicator switch to the vehicle.
2. Connect the retainer to the switch.
3. Install the retaining screw.
NOTICE: Refer to Fastener Notice in Service Precautions.
^
Tighten the retaining screw to 4 Nm (35 inch lbs.).
4. Install the electrical connector.
5. Install the negative battery cable.
^
Tighten the negative battery cable to 15 Nm (11 ft. lbs.).
