K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
1. Lube the new O-ring with engine oil.
2. Install the sensor in the engine.
NOTE: Refer to Fastener Notice in Cautions and Notices.
3. Install the sensor mounting bolt.
Tighten
Tighten the mounting bolt to 25 N.m (18 lb ft).
4. Install the sensor electrical connector.
5. Install the power steering pump.
6. Install the negative battery cables.
IMPORTANT: A new TDC Offset must be learned after replacing a crankshaft position sensor. Refer to TDC Offset Adjustment. See: Testing and
Inspection
