K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
2. Remove the ignition key.
3. Put on safety glasses.
4. Remove all loose objects from the front seats.
5. Disconnect the Inflatable Restraint Steering Wheel Module yellow 2-way connector.
6. Cut the yellow 2-way harness connector out of the vehicle, leaving at least 160 mm (6 in) of wire at the connector.
7. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
8. Cut two 4.6 meter(15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the driver
deployment harness.
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
10. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the air bag.
11. Twist together one connector wire lead to one deployment wire.
12. Inspect that the previous connection is secure.
