K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
1. Install the pump.
2. Install the front mounting bolts.
-
Tighten the bolts to 50 Nm (37 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the rear mounting nuts to the studs.
-
Tighten the nuts to 50 Nm (37 ft. lbs.).
4. Install the pulley.
4.1. Place the pulley on the end of the pump shaft.
4.2. Install the J 25033-C.
4.3. Be sure the pilot bolt bottoms in the pump shaft by turning the nut to the top of the pilot bolt.
4.4. Hold the pilot bolt.
4.5. Turn the nut clockwise.
4.6. Connect the pulley to the end of the power steering pump shaft. Install the pulley flush with 0.5 mm (0.020 inch) play.
Notice: Do not use an arbor press or internal damage to the pump will result.
5. Install the drive belt.
6. Install the hoses.
7. Install the electrical connector to the EVO actuator.
8. Fill and bleed the system.
9. Inspect the hoses and the wiring for clearance.
