K 1500 Truck 4WD V8-6.5L DSL Turbo VIN S (1999)
1. Install the hoist to the crossmember.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolts and the nuts.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
3. Install the pin and the retainer to the shaft.
4. Install the spare tire.
4.1. Place the tire on the ground, with the valve stem pointed down, at the rear of the vehicle.
4.2. Pull the wheel retainer through the wheel opening.
4.3. Attach the ratchet to the wheel with the UP mark facing you.
4.4. Place the end of the wheel wrench through the rear bumper access hole until the wrench connects into the hoist shaft.
4.5. Turn the ratchet clockwise in order to raise the tire.
4.6. When two clicks are heard, stop turning the wrench.
