K 1500 Yukon 4WD V8-4.8L VIN V (2003)
2. Remove the screws retaining the seat back release handle and the seat recliner handle, if equipped.
3. Remove the trim panel (1) by pulling outward in order to disengage the retaining clip.
4. Remove the trim panel from the seat.
INSTALLATION PROCEDURE
1. Position the trim panel on the seat from the front to the back.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Instal the trim panel (1) to the seat by pushing in until the retaining clips are locked in place.
3. Install the screws retaining the seat back release handle and the seat recliner handle to the seat, if removed.
Tighten
Tighten the screws to 2 N.m (18 lb in).
Trim Panel Replacement - Hinge Pillar
Trim Panel Replacement - Hinge Pillar
Removal Procedure
