K 1500 Yukon 4WD V8-5.3L VIN Z Flex Fuel (2003)
1. Install the clip in the slot of the seat frame.
2. Install the rubber band on the clip to retain it in place.
3. Fold down the seat cover.
4. Install the arm rest by pressing in until it is fully seated.
5. Connect the heating element wire connector.
6. Pull down on the seat cover in order to install the 2 push pins retaining the seat back to the card board.
7. Connect the J-clip at the bottom of the seat.
8. Push on the seat back cover to ensure the cover is held in place by the velcro.
Armrest Replacement - Rear Seat (60/40 Split)
Armrest Replacement - Rear Seat (60/40 Split)
Removal Procedure
1. Remove the cover to gain access to the center armrest bolts, if equipped.
2. Remove the bolts that retain the center armrest to the seat frame.
3. Remove the center arm rest from the vehicle.
Installation Procedure
1. Install the center armrest to the seat frame.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the center armrest.
Tighten the bolt to 9 N.m (80 lb in).
3. Install the cover to the center armrest, if removed.
Armrest Replacement - Rear Seat (Bucket)
ARMREST REPLACEMENT - REAR SEAT (BUCKET)
REMOVAL PROCEDURE
