K 1500 Yukon 4WD V8-5.3L VIN Z Flex Fuel (2003)
4.
Remove the nut, the metal washer and the plastic washer from the pivot point of the passenger side cupholder door.
5.
Install a new felt washer, P/N 15197151, over the existing felt washer at the pivot point area shown. Ensure that the washer is centered so that the
door does not bind.
6.
Install the plastic washer, the metal washer and the nut on the pivot point of the cupholder door.
7.
Attach the harness connector at the console lower bezel and install the bezel.
8.
Attach the harness connector at the console upper bezel and install the bezel. Refer to the Bezel Replacement - Floor Console Luxury Upper
Replacement procedure in the Instrument Panel, Gauges and Console sub-section of the Service Information (SI).
9.
Install the IP cluster bezel. Refer to the Bezel Replacement - Instrument Panel (I/P) Cluster Replacement procedure in the Instrument Panel,
Gauges and Console sub-section of the Service Information (SI).
10.
Reset the clock.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
