K 1500 Yukon 4WD V8-5.3L VIN Z Flex Fuel (2003)
4. While supporting the adjustment arm, slide the torsion bar rearward until the torsion bar fully engages the adjustment arm.
5. Install the J 36202 to the adjustment arm and the crossmember.
6. Increase the tension on the adjustment arm in order to load the torsion bar.
7. Install the adjustment bolt (3) and the adjuster nut (4).
IMPORTANT: Install the adjustment bolt the same amount of turns that were required to remove the bolt during removal.
8. Remove the J 36202 releasing the tension on the torsion bar until the load is taken up by the adjustment bolt.
9. Remove the safety stands.
10. Lower the vehicle.
11. Measure the Z height. Refer to Trim Height Inspection Procedure in Suspension General Diagnosis.
12. Turn the adjustment bolt (2) clockwise to increase the Z height and counterclockwise to decrease the Z height.
