K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Headliner: Service and Repair
Headliner Replacement
Headliner Replacement
Removal Procedure
1. Remove the IP top trim panel.
2. Remove the drivers side accessory housing (1) from the IP.
3. Remove the IP upper brackets.
4. Remove the transfer case control module, if equipped.
5. Release the pressure on the headliner wire harness by removing the wire harness retainer (1) from the IP support beam.
6. Disconnect the headliner wire connectors from the junction block located next to the brake pedal.
7. Remove the wire harness retainers along the windshield pillar.
8. Follow the routing of the wire harness through the IP and release any wire harness retainers.
9. Carefully pull out the wire harness from the windshield pillar ensuring that the wire harness does not get caught on any part.
10. Remove the center trim pillar moldings.
11. Remove the third pillar trim pillar moldings.
12. Remove the rear corner trim pillar moldings.
13. Disconnect the electrical connector to the rear view mirror.
14. Remove the upper console.
15. Remove the front sunshades.
16. Remove the sunshade holders.
17. Remove the rear coat hook, if equipped.
