K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Sunroof / Moonroof Wiring Harness: Service and Repair
REMOVAL PROCEDURE
1. Remove the headliner.
IMPORTANT: Observe the routing of the wire harness. Failure to route the wire the same will result in the wire harness being pinched during
sunroof operation.
2. Disconnect the wire harness connectors (5) and (6).
3. Remove the wire from the sunroof module.
INSTALLATION PROCEDURE
1. Connect the wire connector (6).
IMPORTANT: Do not route the wire harness on the top or the bottom of the flange as it will get pinched during sunroof operation.
2. Secure the wire harness along the out board flange (7) and (2).
3. Secure clip (1) and clip (3) to sunroof module flange.
4. Loop the wire harness around cable drive (4).
5. Connect the wire harness (5) to the sunroof motor.
6. Install the headliner.
7. Inspect the operation of the sunroof.
