K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
DISCLAIMER
Service Procedure
The following are instructions for installing support covers on the SECOND ROW rear seat head restraints. There are a total of four (4) covers to be
installed (two per head restraint).
1.
Open the rear side doors for access to the second row seat.
2.
Release both rear seat cushions by pulling up on the strap loops located at the rear center of each seat cushion. Once released, continue pulling the
seat cushion up and then fold it forward.
Caution
Keep fingers away from the pinch points when the head restraints fold rearward as the seatback is being lowered in the next step.
3.
Raise both second row rear seat head restraints to the full up position and tilt both rear seatbacks forward.
4.
Insert an awl or pointed tool into the small hole (1) in the retainer located at the bottom of the head restraint while slightly pulling upward on the
restraint. Repeat this step on the second support of the head restraint.
5.
Remove the head restraint.
6.
Raise the head restraint supports (1) to a vertical position and carefully open the slit (3) in the seatback fabric (2). The illustration shows the left
slit being closed and the right slit when open.
