K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Trunk / Liftgate Weatherstrip: Service and Repair
Weatherstrip Replacement - Mid Gate - Lower
Weatherstrip Replacement - Mid Gate - Lower
Removal Procedure
1. Fold down the rear seat.
2. Remove the rear removable glass panel.
3. Remove the midgate.
4. Remove the floor hinge molding.
5. Starting from one end remove the weatherstrip from the vehicle.
Installation Procedure
Important: To begin the installation of the weatherstrip, ensure the weatherstrip is at a minimum of 21°C (70°F).
1. Starting from one end of the weatherstrip, install the weatherstrip.
2. Ensure the corners of the weatherstrip are fully seated.
3. Install the floor hinge molding.
4. Install the midgate.
5. Close the midgate.
6. Install the rear removable rear glass panel.
7. Inspect the weatherstrip when the midgate is closed and the glass panel installed.
8. Set the rear seat in the upright position.
