K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Notice: Refer to Fastener Notice in Service Precautions.
1. Quickly install the new brake fluid pressure sensor (2) to the BPMV as soon as the old sensor has been removed.
Use a wrench to keep the brake fluid pressure sensor collar from turning (1).
Tighten the brake fluid pressure sensor to 16 Nm (12 ft. lbs.).
2. Install the alien bolt (2) to the Brake Pressure Modulator Valve (BPMV) mounting bracket (3).
Tighten the alien bolt to 9 Nm (7 ft. lbs.).
3. Connect the electrical connector to the brake fluid pressure sensor.
4. Lower the vehicle.
5. Check and fill the brake fluid level in the master cylinder.
