K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
2. Install the brake hose to caliper bolt-rear, and 2 New washers to the brake caliper.
Tighten the bolt to 40 Nm (30 ft. lbs.).
Important: The brake hose must not be twisted. Make sure the brake hose is not in contact with any suspension component.
3. Install the brake hose (1) into the mounting bracket.
4. Install the brake hose retaining clip (3).
5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
6. Connect the brake pipe fitting end (2) to the brake hose (1):
^
Use a backup wrench on the brake hose fitting end (1).
^
Do not bend the mounting bracket or the brake pipe.
Tighten the brake pipe fitting end (2) to 25 Nm (18 ft. lbs.).
7. Bleed the hydraulic brake system.
8. Install the tire and wheel assembly.
Important: Ensure that the brake hose does not make contact with any part of the suspension or the tire/wheel assembly. If the brake hose makes
contact remove the brake hose and correct the condition.
9. Lower the vehicle.
Rear Jounce
Brake Hose Replacement - Rear (Jounce)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Clean all dirt and foreign material from the brake hose and brake pipe fittings.
Important: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
