K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the pressure accumulator switch to the BPMV.
Tighten the switch to 3 Nm (30 inch lbs.).
2. Install the brake fluid pressure sensor (2) using a backup wrench to keep the brake fluid pressure sensor collar (1) from turning.
Tighten the sensor to 16 Nm (12 ft. lbs.).
Important: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
3. Install the EBCM (2) onto BPMV (1).
4. Install the four EBCM bolts.
Important: Do not reuse the old mounting bolts. Always install new EBCM bolts with the new BPMV.
Tighten the bolts to 5 Nm (39 inch lbs.) in an X-pattern.
5. Connect the brake fluid pressure sensor and pressure accumulator switch electrical harnesses.
6. Install the BPMV (1) to EHCU bracket (3).
7. Install the BPMV to bracket retaining bolts (4).
Tighten the bolts to 9 Nm (7 ft. lbs.).
