K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
8. Install the cable to the mounting bracket until the locking tabs snap into place.
9. Connect cable end to the equalizer.
10. Tighten the nut to the intermediate cable at the equalizer.
Tighten the nut to 3.5 Nm (31 inch lbs.).
11. Remove the safety stands.
12. Lower the vehicle.
13. Adjust the park brake cable.
Right Rear (Without/RPO NYS)
Park Brake Cable Replacement - Right Rear (without/RPO NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Relieve the tension on the cable by loosening the nut at the equalizer.
4. Disconnect the cable from the equalizer.
