K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
8.
Remove the rotor from the hub. If the rotor cannot be removed from the hub by pulling on the rotor, use J 46277 rotor removal tool.
Notice:
Place J 46277 between the rotor surfaces in the vent section of the rotor. DO NOT place J 46277 on the back side of the rotor surface, it may damage
the rotor surface.
9.
Using removal tool J 46277 on slide hammer J 6125B, remove the rotor by placing removal tool J 46277 in the vent section of the rotor at the
twelve, three, six and nine o'clock positions, not necessarily in that order.
10.
Clean the rust ridge from the drum portion of the rotor using a grinding stone and rotor resurfacing kit J 41013.
11.
Remove the spring clip bolt (3) and retainer (2) and discard.
Important:
Minimum thickness of the parking brake shoe lining in any given spot is 1.5 mm (0.06 in).
12.
Measure the parking brake shoe thickness in multiple spots. Replace the parking brake shoe if the thickness is less than 1.5 mm (0.06 in). Continue
with Step 14.
13.
If the parking brake shoe lining is greater than 1.5 mm (0.06 in), continue with Step 19.
