K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
14.
Rotate the parking brake shoe (1) out from the bottom and pull it out of the adjuster. Discard the shoe.
15.
Remove the park brake shoe assembly from the vehicle by placing one of the open ends of the shoe over the axle flange and rotate the shoe until it
has cleared the flange.
16.
Turn the adjustment screw (1) to the fully home position in the notched adjustment nut.
17.
Install the new park brake shoe assembly (1) from the parking brake shoe kit, P/N 88982875, to the vehicle by placing one of the open ends of the
shoe over the axle flange and rotating the shoe until it is behind the flange.
18.
Slide the shoe into the adjuster and position the shoe to the backing plate. Install the retaining spring clip (2) and bolt (3) from the parking brake
shoe kit, P/N 88982875. If using parking brake service kit 88982875, SKIP Step 19.
19.
Replace the retaining spring clip (2) and bolt (3) from the parking brake retaining spring clip kit, P/N 88982879.
Tighten
Tighten the bolt (3) to 5 N.m (44 lb in).