K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Important: Install the retainer plate with the sealing gasket facing the engine block.
The gasket surface on the engine block should be clean and free of dirt and/or debris.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the camshaft retainer and bolts.
-
Tighten the camshaft retainer bolts to 25 Nm (18 ft. lbs.).
6. Inspect the camshaft sensor O-ring seal. If the O-ring seal is not cut or damaged, it may be reused.
7. Lubricate the O-ring seal with clean engine oil.
8. Install the camshaft sensor and bolt.
-
Tighten the camshaft sensor bolt to 25 Nm (18 ft. lbs.).
9. Install the timing chain and camshaft sprocket.
10. Install the valve lifters.
11. Install the radiator support.
