K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
4. Place the J 33019 in the hub bore.
5. Shift the rotor and bearing assembly on the J21352-A in order to fully support the hub under the staking pin location.
Use a heavy-duty rubber band (1) in order to hold the stake pin in the guide. Properly position the stake pin in the guide after each impact on the
pin.
CAUTION: Use care in order to prevent personal injury when striking the staking pin with a hammer.
6. Strike the staking pin with a hammer until a metal stake, similar to the original, forms down to but not touching the bearing.
IMPORTANT: Noisy bearing operation and reduced bearing life may result if the outer bearing race is deformed while staking. Ensure that the stake
metal does not contact the outer race of the bearing.
7. Stake 3 locations on the bearing race 120 degrees apart as shown.
