K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
61.
Connect the wiring harness to the fan motor connector.
62.
Remove the bolt from the right end of the cross beam of the hood latch, install the eyelet of the black wire, and reinstall the bolt.
63.
Place a tie strap around the cross beam and wiring harness on each side of the transmission cooler and one on the A brace left leg where the wiring
harness passes over it.
64.
Reinstall the grille.
65.
Remove the upper fan support bracket. Place the bracket in a vise to straighten the bends in the two legs of the bracket.
66.
Reinstall the bracket to the fan assembly.
67.
Carefully bend the two legs of the fan assembly bracket. Starting with the left leg, bend it so the leg comes into contact with the radiator support
top bar.
68.
Then fit the right leg to the radiator support top bar.
69.
When you feel the legs have been properly formed, try to re-install the upper radiator baffle, do not install the retainers, when satisfied everything
will fit properly. Drill two 6.4 mm (1/4 in) holes into the upper radiator support and install a rivet in each hole in order to retain the upper bracket
of the fan assembly to the radiator upper bar.
70.
Make sure the fan spins freely. If not, adjust the mounting to allow the fan to spin freely.
71.
Reinstall the upper radiator baffle.
72.
Reinstall the underhood electrical center covers.
73.
Remove the bolt supporting the new relay and place the bolt through the support brace, the ground wire for the relay, and then the relay bracket.
Reinstall the bolt into the radiator support, then reinstall the bolt in the fender end.
Tighten
Tighten the brace bolts to 25 N.m (18 lb ft).
74.
Connect the battery cables.
Tighten
Tighten the battery terminal bolts to 17 N.m (13 lb ft).
