K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Camshaft Position Sensor: Service and Repair
REMOVAL PROCEDURE
IMPORTANT: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.
Camshaft Position Sensor (CMP)
1. Remove the engine sight shield, as necessary.
2. Disconnect the CMP sensor electrical connector.
3. Remove the CMP sensor bolt.
4. Remove the CMP sensor.
INSTALLATION PROCEDURE
Camshaft Position Sensor (CMP)
1. Install the CMP sensor.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the CMP sensor bolt.
Tighten
Tighten the bolt to 25 N.m (18 lb ft).
3. Connect the CMP sensor electrical connector.
4. Install the engine sight shield, as necessary.
