K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
4. Remove the TP sensor attaching screws (5).
5. Remove the TP sensor (6).
6. Remove the TP sensor O-ring seal (7).
INSTALLATION PROCEDURE
1. Install the TP sensor O-ring seal (7) on the TP sensor (6).
2. Install the TP sensor on the throttle body with the throttle valve in the closed position. Verify the TP sensor lever lines up with the TP sensor drive
lever on the throttle shaft.
NOTE: Refer to the Fastener Notice in Service Precautions.
3. Install the TP sensor attaching screws (5).
Tighten
Tighten the screws to 2 N.m (18 lb in).
