K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Important:
^
If the motor/encoder assembly is being replaced because it is defective, make sure that the transfer case is in the neutral position. Manually shift
the unit at the shift shaft. Use a crescent wrench if necessary.
^
When installing the motor/encoder unit to the transfer case, make sure that the transfer case is indexed properly and it is flat against the transfer
case before tightening the mounting bolts.
1. Install the NEW motor/encoder gasket to the transfer case.
2. Install the motor/encoder to the transfer case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install motor/encoder mounting bolts.
^
Tighten the bolts, in the sequence shown, to 20 Nm (15 ft. lbs.).
4. Install the motor/encoder electrical connector. Ensure that the retention clips activate.
5. Install the front propeller shaft.
6. Install the transfer case shield.
7. Lower the vehicle.
