K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Electronic Brake Control Module: Service and Repair
Electronic Brake Control Module (EBCM) (W/JL4)
Electronic Brake Control Module (EBCM) Replacement (w/ JL4)
Removal Procedure
Important: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.
Caution: Refer to Battery Disconnect Caution in Service Precautions.
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Important: The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.
3. Thoroughly wash all contaminants from around the EHCU (1).
4. Disconnect the brake fluid pressure sensor (7) and pressure accumulator switch (4) electrical connectors.
5. Remove the four mounting screws that fasten the EBCM (2) to the BPMV (1).
6. Remove the EBCM (2) from the BPMV (1). Removal may require a light amount of force.
Important: Note the routing of the jumper harnesses for reinstallation.
7. Remove the EBCM and jumper harnesses from the vehicle.
8. Remove the jumper harnesses from the EBCM
9. Clean the BPMV to EBCM mounting surfaces with a clean cloth.
Installation Procedure
1. Install the jumper harnesses to the EBCM.
2. Install the EBCM and jumper harnesses to the vehicle.
