K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
1. Align the block tooth on the upper shaft to the 12 O'clock position.
NOTE: Ensure all fasteners are securely seated before applying needed torque. Failure to do so may result in component damage or malfunctioning
of steering column.
2. Install the wave washer (1) to the steering column upper shaft.
IMPORTANT:
^
Verify that the SIR steering wheel module coil is centered.
^
The SIR steering wheel module coil becomes uncentered under the following conditions:
-
The steering column is separated from the steering gear and allowed to rotate.
-
The centering spring is pushed down, letting the hub rotate while the coil is removed from the steering column.
^
If the SIR steering wheel module coil becomes uncentered, refer to the following procedures:
-
For the standard column, refer to Inflatable Restraint Coil Centering - Off Vehicle (Column Shift And Floor Shift) in Steering Wheel and
Column - Standard.
-
For the tilt column refer to Inflatable Restraint Coil Centering Off Vehicle (Column Shift And Floor Shift) in Steering Wheel and Column -
Tilt.
