K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
6. Clear an area on the floor approximately 1.85 m (6 ft) in diameter for deployment of the inflator module. If possible, use a paved, outdoor location
free of activity. Otherwise, use an area free of activity on the shop floor. Make sure you have sufficient ventilation.
7. Make sure no loose or flammable objects are in the area.
8. When deploying a steering wheel module, place the steering wheel module in the center of the cleared area.
9. When deploying an IP module refer to the following instructions:
^
Place the J 39401-B (2) in the center of the cleared area.
^
Fill the deployment fixture (2) with water or sand.
^
Mount the IP module (1) in the deployment fixture (2) with the vinyl/plastic trim facing up.
^
To mount, use 4 M 6 bolts (6), nuts (8), and washers (7) to properly secure the IP module (1) to the deployment fixture (2).
^
Tighten all fasteners prior to deployment.
10. When deploying a side impact module, refer to the following instructions:
^
Place the J 39401-B SIR deployment fixture (3) in the center of the cleared area.
^
Fill the deployment fixture (3) with water or sand.
^
Mount the side impact module (1) in the deployment fixture (3) with the vinyl/plastic trim facing up.
^
Adjust and secure the J 39401-B arms (4) to the deployment fixture (3).
^
To mount, use 2 M 6 x 1.0 nuts (2) with washers to secure the side impact module (1) to the deployment fixture arms (4).
^
Tighten all fasteners prior to deployment.
