K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
7. Perform the following steps in order to complete the fastener repair:
7.1.
Remove and discard the improperly installed fastener.
7.2.
Chisel off the damaged weld nut.
7.3.
Condition the front end lower tie surface where the new weld nut is to be installed.
7.4.
Install the new weld nut (GM P/N 11514034) or equivalent into position.
7.5.
Migweld the new weld nut to the front end lower tie surface in the correct location.
7.6.
Use the new fastener (GM P/N 11515926) or equivalent.
INSTALLATION PROCEDURE
CAUTION: Be careful when you handle a sensor. Do not strike or jolt a sensor. Before applying power to a sensor:
^
Remove any dirt, grease, etc. from the mounting surface.
^
Position the sensor horizontally on the mounting surface.
^
Point the arrow on the sensor toward the front of the vehicle.
^
Tighten all of the sensor fasteners and sensor bracket fasteners to the specified torque value.
Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system repairs.
1. Install the inflatable restraint front end discriminating sensor to the front end lower tie surface. Make sure the arrow is pointing toward the front of
the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
