K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Ride Height Sensor: Service and Repair
Rear Position Sensor Replacement - Electronic Suspension
Rear Position Sensor Replacement - Electronic Suspension - Left
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel and tire assembly from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Remove the bolt from the Real Time Damping (RTD) sensor link bracket.
5. Spread the bracket open until the bracket can be removed from the upper control arm.
6. Remove the bolts from the frame.
7. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the frame.
Tighten the bolts to 12 Nm (106 inch lbs.).
