K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
11.
From the technicians point of view, the FRONT of the sensor will have:
^
A raised rotor flange cuff (3)
^
An alignment mark (2) on the rotor flange cuff (3) for installation
^
A pin hole (1) for the centering pin (note location of the pin hole)
12.
Remove the connector from the sensor.
13.
Remove the sensor from the adapter and bearing assembly.
14.
To install the sensor, proceed to step 9 in the installation section.
15.
From the technicians point of view, the FRONT of the sensor will have:
^
A raised rotor flange cuff (3)
^
An alignment mark (2) on the rotor flange cuff (3) for installation
^
A pin hole (1) for the centering pin (note location of the pin hole)
^
A sensor clip in FRONT of the sensor
16.
Remove the connector from the sensor.
17.
Remove the sensor clip from the sensor.
18.
Remove the sensor from the adapter and bearing assembly.
19.
To install the sensor, proceed to step 13 in the installation section.
