K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
1. Install the position sensor into the bearing assembly.
Important: Do not apply force to the sensor and the bearing in a sideways direction.
2. Install the bearing into the steering column jacket.
2.1.
Align the notches on the bearing and the column jacket.
2.2.
Seat the bearing fulling into the jacket.
3. Connect the position sensor connector.
Notice: Refer to Fastener Notice in Service Precautions.
4. Slide the shaft up to install the bolt and the nut (1) to the upper intermediate shaft to steering column connection.
Tighten the upper intermediate shaft connection to 47 Nm (35 ft. lbs.).
5. Enable the SIR system.
