K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
Shock Absorber Replacement
Shock Absorber Replacement
Removal Procedure
Notice: The front shock absorbers of the vehicle are multifunctional. In addition to contributing to a smooth ride they also provide the only stop to the
front suspension when fully extended. Therefore, when servicing the shock absorber, service replacement shock absorbers must be equivalent to
original shock absorbers in both extended length and strength. Use of shocks not complying to original equipment or strength could result in
suspension over-travel or shock breakage. Suspension over-travel may result in suspension component breakage.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the lower control arm with a jack stand.
3. Disconnect the (RTD) link rod from the sensor, if equipped.
4. Disconnect the electrical connector if equipped with selectable ride, if equipped.
5. Grasp the connector lock tabs (1, 2). Rotate the connector tabs counterclockwise until the connector is unlocked.
6. Disengage the connector from the tennon by firmly pulling the connector up.
7. Hold the tennon end with a wrench while removing the nut.
