K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
Drive/Propeller Shaft: Service and Repair
Propeller Shaft Replacement- Front
Propeller Shaft Replacement- Front
^
Tools Required
-
J 43218 Clamp Pliers Narrow Jaw
Removal Procedure
Important: Before disassembly, observe and accurately mark all of the driveline components relative to the propeller shaft and to the axles. These
items include the following components:
^
The propeller shafts
^
The wheel drive shafts
^
The pinion flanges
^
The output shafts
Assemble all of the components in the exact relationship to each other prior to removal. Observe all published specifications and torque values, and
any measurements obtained prior to disassembly.
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield, if equipped.
3. Mark the relationship of the propeller shaft and of the front axle pinion yoke.
4. Remove the clamp (4) at the transfer case (3) by prying up the exposed end of the clamp (4) with a flat-bladed tool.
5. Remove the bolts (6) and the yoke retainers (7) from the front axle pinion yoke (1).
Notice: When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke and the
universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the joint.
6. Disconnect the propeller shaft (2) from the front axle pinion yoke (1).
Wrap the bearing caps with tape in order to prevent the loss of bearing rollers.
Important: Do not drop the bearing cap assemblies of the yoke end.
