K 1500 Yukon Denali AWD V8-6.0L VIN U (2002)
^
The wheel drive shafts
^
The pinion flanges
^
The output shafts
Assemble all of the components in the exact relationship to each other prior to removal. Observe all published specifications and torque values and
any measurements obtained prior to disassembly.
2.
Remove the transfer case shield, if equipped.
3.
Remove the clamp (if applicable) (4) at the transfer case (3) by prying up the exposed end of the clamp (4) with a flat-bladed tool.
4.
Remove the bolts (6) and the yoke retainers (7) from the front axle pinion yoke (1).
Notice:
When removing the propeller shaft, do not attempt to remove the shaft by pounding on the yoke ears or using a tool between the yoke and the
universal joint. If the propeller shaft is removed by using such means, the injection joints may fracture and lead to premature failure of the joint
5.
Disconnect the propeller shaft (2) from the front axle pinion yoke (1).
6.
Remove the propeller shaft (5) from the transfer case output shaft by sliding the propeller shaft forward.
7.
Inspect the splines of the transfer case output shaft for a sufficient coating of lubricant. If the output shaft does not have a sufficient coating of
lubricant, lubricate the shaft with lubricant, P/N 12345879 (Canadian P/N 10953511), or with an equivalent lubricant meeting GM specification
