K 1500 Yukon XL 4WD V8-5.3L VIN T (2001)
Brake Hose/Line: Service and Repair
Rear Caliper
Brake Hose Replacement - Rear (Caliper)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove all dirt, grease, or other foreign material from the hose fittings.
4. Disconnect the hose from the brake pipe at the axle.
5. Remove the brake hose retaining clip.
6. Remove the brake hose bolt from the axle.
7. Remove the brake hose mounting bolt and the compression washers at the caliper.
8. Remove the brake hose.
9. Discard the washers.
Installation Procedure
