K 1500 Yukon XL 4WD V8-5.3L VIN T (2001)
3. Remove the transfer case input shaft seal.
Installation Procedure
Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer
case).
1. Align the transfer case input shaft seal evenly on the input shaft.
Important: The input shaft seal should be even with the surface of the transfer case after installation.
2. Using the J 42738, install the transfer case input shaft seal.
3. Install the transfer case assembly in the vehicle.
4. Check the transfer case fluid level.
5. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case - NVG 261-NP2 (Two Speed Manual)
Transfer Case Input Shaft Seal Replacement
