K 1500 Yukon XL 4WD V8-5.3L VIN T (2001)
-
J 37668-A Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.
3. Remove the rear propeller shaft.
^
For vehicles equipped with the one piece propeller shaft, refer to Propeller Shaft Replacement - One Piece.
^
For vehicles equipped with the two piece propeller shaft, refer to Propeller Shaft Replacement - Two Piece.
4. Remove the transfer case rear output shaft seal.
Installation Procedure
1. Position the transfer case rear output shaft seal in the transfer case.
2. Using the J 37668-A, install the transfer case front output shaft.
3. Install the rear propeller shaft.
^
For vehicles equipped with the one piece propeller shaft, refer to Propeller Shaft Replacement - One Piece.
^
For vehicles equipped with the two piece propeller shaft, refer to Propeller Shaft Replacement - Two Piece.
4. Check the transfer case fluid level.
5. Install the transfer case shield.
6. Lower the vehicle. Refer to Vehicle Lifting.
Transfer Case Output Shaft Seal Replacement - Front
Transfer Case Output Shaft Seal Replacement - Front
^
Tools Required
-
J 8092 Universal Handle
-
J 43484 Front Output Shaft Seal Installer
Removal Procedure