K 1500 Yukon XL 4WD V8-5.3L VIN Z Flex Fuel (2002)
*
Park brake cable-Leave slack in the cable.
*
Body ground straps-Leave slack in the wire.
Lower the chassis accordingly in order to remove the cushions (1) as necessary.
Installation Procedure
1. Install the cushions (1) as necessary and raise the chassis accordingly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the body mount bolts.
Tighten the bolts to 85 N.m (63 lb ft).
3. Install the park brake equalizer intermediate cable. Perform the following steps:
1. Pull rearward on the park brake cable to the original position.
2. Secure the cable retaining tabs to the frame.
3. Install the intermediate cable end to the equalizer.
4. Install the nut to the threaded end of the intermediate cable.
Tighten the nut to 3.5 N.m (31 lb in).
4. Install the running boards, if equipped.
5. Lower the vehicle.
6. Install the master cylinder. Perform the following steps:
1. Mount the master cylinder to the brake booster.
2. Install the master cylinder mounting nuts.
Tighten the nuts to 36 N.m (27 lb ft).
7. Install the front lamp harness ground bolt (1).
Tighten the bolt to 6 N.m (53 lb in).
8. Install the front bumper.
